Mid-range in-circuit debugger and programmer for Atmel 8-bit and 32-bit AVR microcontrollers with on-chip debugging for source level symbolic debugging, NanoTrace (if supported by the device) and device programming.
JTAGICE3 supports the following programming modes:
It also supports debugging using the following interfaces:
Supports a large number of AVR devices
Supports up to 3 hardware program breakpoints or 1 maskable data breakpoint (depending on the OCD module on the AVR device)
Supports symbolic debug of complex data types including scope information.
Supports up to 128 software breakpoints
Level converters support 1.8V to 5.5V target operation
Uploads 256Kb code in ~ 15 seconds (XMEGA using JTAG interface)
Hi-Speed USB connection to host PC Firmware upgradeable for supporting future AVR devices
Supports NanoTrace (depending on the OCD module on the AVR device; uses target device's memory)
JTAGICE3 is supported by Atmel Studio.
The JTAGICE3 kit also includes adapters for use with the various physical interfaces.
- USB High Speed cable ~1.5m
- 50-mil squid cable
- 50-mil IDC cable
- Adapter kit consisting of 10-pin 100 mil, 6-pin 100 mil, and 6-pin 50 mil